DT Research WebDT 435 Guide de l'utilisateur télécharger pdf (Page 13)

Rev Date 9/16/2010

Touch Screen Calibration

The first time you turn on the WebDT 435, the system will automatically

direct you to do a screen calibration.

To calibrate the WebDT435 touch screen again, follow the steps below:

Hold the function key

and press to start calibration.

Click

Start

→

Settings

→

Control Panel

→

Stylus

Select

Calibration

tab  Click

Recalibrate

button (as shown at right

side).

Follow the instructions described on the screen to complete the touch

screen calibration.

After starting to run the touch calibration, if users do not touch the

screen within 30 seconds, the operation will be automatically

terminated.

If users do not perform the calibration precise enough, then the

calibration process will be activated again until the calibration is done

precisely or cancelled by users.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 41 42

Pas de commentaire

DT Research WebDT 435 Guide de l'utilisateur Page 13